Mill Issues

I understand that the mill issues have been resolved but I am experiencing a little bit different issue. The one that was widespread seems to be fixed on my farm(s) but the new problem is this:

The mill continues to turn even though it is not milling. I normally am triggered to start new feed when the mill stops so when I go to the mill to see how much longer the mill is going to take before starting a new feed, I have been surprised that it has already finished its cycle. This is the case on both farms and on the main and island mills.

I have done all the normal troubleshooting and am on different browsers for the different farms.

ID:42614584
2nd farm ID:50184161

 

Hello puppiesnponies,

I am not able to reproduce this, and on your farms, the mill is running at the moment. Could you please let us know when it stops so we can check it? ​

 

I will let you know....it looks like the mill has another couple of hours.

Edit: I knew the mill was supposed to be close to finishing a few minutes before 4:00. On Baha, the mill was still spinning but when I clicked to see how many more minutes, it stopped. I was able to select the next feed to mill. The main mill is milling. I guess I will have to write down the exact time that it finishes since checking it makes it stop. Will try again....sorry

Edit 2: Main mill was not milling as I thought but still spinning. I went in to the main mill to write down its finish time and it is not milling but is spinning. But again, like Baha mill, just opening the mill to see the time makes it stop.

Edit 3: I did 2 rounds of chicken feed: 1 unit and then 2 units. Both times the mill did stop spinning....I am assuming either the problem is fixed or it is affected by longer feed times. I have set some goat feed to mill and will be ready in a few hours.

You can either leave this open to another update or close if you wish and I will post again if the problem continues.

Edit 4: I just checked BW farm and the mill did indeed stop after milling so maybe all is well again...

Thank you to whoever sprinkled magic dust on the mill. You may close.
Leaves a basket of goodies made just for you....

 

Hello puppiesnponies

Thank you very much for letting us know - I really hope your mill was just hyperactive for a little bit I have tried having one mill working, then both, then neither - then I have let it finish milling, and it stopped, all cases worked correctly If it happens again, please let us know and I will give it another try.

Thank you very much for the basket of goodies, yummmy Promise I won't touch the hedgehog (so cute!).
​

~ Closing thread as the mill appears to be working now ~